ChimeTimer

30 Second Timer

Set and ready. Press Start or Space.

Ready30 sec · Bell00:3000min30sec

Recent timers

Timers you finish show up here, one click to run again.

Your presets

Press Save preset on any timer to keep it here.

How to use it

  1. Pick a timeTap a preset above the timer, or type your own time below it.
  2. Start itPress Start or Space. Add a label so you remember what it is for.
  3. Hear the alarmIt rings on time in a background tab and on any page of this site.

What 30 seconds is good for

Thirty seconds is the standard hold for a static stretch, a manageable first plank, and the length of a short elevator pitch. In the kitchen it is one microwave burst when you are softening butter or reheating in stages.

The page opens with the time set and Start focused. Press Space to begin, R to reset and plus or minus to change it by a minute.

Stretch holdsHold each stretch long enough to make a difference.
Plank for beginnersA steady first goal before moving up to a minute.
Elevator pitchPractise saying what you do in half a minute.
Microwave burstsShort rounds when melting chocolate or softening butter.

Getting more from a half-minute stretch

Breathe out slowly as you ease into the position, then hold still once you feel gentle tension. Bouncing does little good. Start the timer only when you are in place, not while you are still getting down to the floor, so the full thirty seconds counts.

Working through a list? Do one side, press Restart, then do the other. The R key resets without touching the screen, which helps when your hands are busy holding a foot.

Half a minute versus longer holds

Thirty seconds is a sensible default for most adults and most muscles. Tight hamstrings or calves may respond better to forty-five seconds or a full minute. For a plank, half a minute is a fair first target; once it feels steady three days running, try the one minute page.

Questions

How long should a 30 second stretch feel?

Longer than you expect. Counting in your head usually runs fast, which is why a visible timer gives a more honest hold.

Can I repeat the 30 seconds automatically?

For repeated holds with rest, use the stretch timer, which runs eight 30 second holds with 10 seconds to switch.

Nearby durations

Customise it in the timer